Emerald Spa DS-4 Manuál s instrukcemi stáhnout pdf (Strana 23)

DS series Instructions manual

7.3. Detection mode (teach-in)

The teach-in mode can be selected using the dip-switches (see

functions 9 and 10 of Tab.1 at page 14) and is active only with one of

these selections.

This mode allows the memorisation of the dimension of one or more

objects (not adjacent) by pressing the SET pushbutton. The PNP

output is then switched on when the objects pass in the sensitive area.

The teach-in mode is activated effecting the following phases:

• Place the object inside the sensitive area in the desired position.

• Press for at least 2 seconds the SET pushbutton.

• Release the pushbutton after the powering on of the red LED.

The object detection is indicated by the successive powering on of the

green LED.

The presence of the memorised object will allow the switching ON of

the digital output (PNP) and powering on of the relative yellow LED.

The characteristics of the memorised object remain valid until another

successive teach-in detection is made.

In the teach-in mode, the system forces the parallel beam mode

independently from the dip-switch setting (dip-switch N°1) that, only in

this configuration, is used to select the detection mode.

The function of the detection mode (teach-in) is active only w ith

the parallel beam mode.

Fig. 12

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

Žádné komentáře

Emerald Spa DS-4 Manuál s instrukcemi Strana 23